8 Mechanical characteristics8.1 Impact strengthPipes with a nominal wall thickness of 14,9 mm or less, when tested for resistance to external blows at 0 °C in accordance with EN 744:1995 shall have a true impact rate (TIR) of not more than 10 % when tested at the levels given in table 6.Pipes in the series…
9.3 Determination of Frost State and No-Frost State:9.3.1 Charge the frost/dew point apparatus with dry ice as described in 9.1 or 9.2.9.3.2 Clean both exterior surfaces of the specimen.9.3.3 Place a piece of silver-colored aluminumized polyester film3 (highly reflective mirror surface, not thicker than 0.08 mm (0.003 in.) and 25 mm (1 in.) in diameter…
6 Test rig and fixtures 6.1 Test rig The test rig shall be a compression or tensile testing machine or similar (shear testing) machine of sufficient capacity to apply the shearing load by activating a ram. The test rig shall provide equipment to register the exact load applied at the instant of shear failure. The…
H.1 GeneralThe test consists of measuring the indentation of a punch into the FJC under fixed conditions of temperature and load. H.2 EquipmentH.2.1 Chamber or bath, thermostatically controlled to ± 2°C;H.2.2 Penetrometer, comprised of⎯ a cylindrical indenter on the top of which is mounted a weight; the assembly, indenter plus weight, shallproduce a pressure in…
Scope This standard specifies a method for testing the resistance of joints to pressure cycling. It is applicable to piping systems based on rigid or flexible thermoplastics pipes intended to be used in hot and cold water applications. 3 Apparatus 3.1 Pressurizing device, capable of applying and regulating the water pressure in the test piece…
4.2 ApparatusThe following apparatus shall be used:a) a device for generating a controlled amount of ozone;b) a means for circulating ozonized air under controlled conditions of humidity andtemperature through a chamber containing the test pieces to be tested;c) a means for the determination of ozone concentration;d) a suitable device for the clamping and elongation of…
4 PrincipleAir is compressed by the weight of a vertical cylinder floating in a liquid. A test piece is in contact with thecompressed air and the cylinder falls steadily as air passes through the test piece. The time for a givenvolume of air to pass through the test piece is measured and from this the…
9.1 Type tests and test sequences 9.1.1 The characteristics of circuit-breakers are verified by means of type tests. Type tests required by this standard are listed in table 8. 9.2 Test conditions The circuit-breaker is mounted individually, vertically and in free air at an ambient temperature between 20 °C and 25 °C, unless otherwise specified,…
6 Test pieces6.1 GeneralMiniature test pieces might give somewhat different, usually higher, values for tensile strength and elongation at break than the larger test pieces.Seven types of test piece are provided, i.e. dumb-bell-shaped types 1, 2, 3, 4 and 1A and ring-shaped types A (normal) and B (miniature). The results obtained for a given material…
8.9 Test 9 — Corner drop test8.9.1 PurposeThe purpose of this test is to determine the diagonal rigidity of the top deck of the pallet and its resistance to impact. 8.9.2 ProcedureMark the two measuring points, A and B, as shown in Figure 9 at approximately 50 mm from the corners of the pallet. While…
