1 SCOPE AND FIELD OF APPLICATION This International Standard specifies a method of determining the apparent density, i.e. the mass per unit of volume, of base material (powder or granular material) that can be poured from a funnel of specified design. NOTE: For a method of degerming the apparent density of loose moulding maternal that…
5 Pendulum method5.1 Apparatus5.1.1 GeneralThe rebound resilience shall be measured by means of an apparatus consisting of a pendulum-like onedegree-of-freedom mechanical oscillatory device and a heavy and secure test piece holder.The two items shall be suitably fixed together for rebound resilience measurements, and either item can be removed for purposes of adjustment or checking of…
6.5 Tension 6.5.1 Three samples of MPT shall withstand a tension of 156 N (35 Ibf) for one minute applied in accordance with 6.5.5 – 6.5.6 Each sample shall be approximately 457 mm (18 inches) in length Following the test, there shall be no splits, cracks, tears, separation of convolutions, or other openings when it…
faces. A jig as shown in Fig. 1 and capable of notching the specimens in accordance with 10.2 shall be used.NOTE 4—It is recommended that the jig be permanently mounted to ensure notching consistency.6.3 Specimen Holders—Lengths of hard or half-hard brass channel having the dimensions shown in (B) of Fig. 2 shall be used. The…
10 Mechanical properties10.1 Mechanical strength10.1.1 Conduit systems shall have adequate mechanical strength. 10.1.2 Conduits, according to their classification, when bent or compressed, or exposed to impact or extreme temperature of a specified value in accordance with impact and temperature classification declared for the product, either during, or after, installation according to the manufacturer’s instructions, shall…
8. Measurement of Test Specimens 8.1 Measure dimensions up to and including 25 mm (1 in.) using a dial-type gauge with a minimum foot area of 650 mm2(1 in.2). Pressure on the foot shall be held to 190 +- 50 Pa (0.028 +- 0.007 psi). NOTE 2—Where foam is appreciably compressed by this test method,…
5 General characteristics 5.2 OpacityPolypropylene pipes that are declared to be opaque shall not transmit more than 0,2 % of visible light, when tested in accordance with ISO 7686. 7 Mechanical characteristicsWhen tested in accordance with the test methods as specified in Table 10 using the indicated parameters, the pipe shall withstand the hydrostatic (hoop)…
Physical Property Test Method Average Density ASTM-D3575 Comp Strength ASTM-D3575 @ 25% @ 50% @ 75% Tensile Strength ASTM-D3575 Tensile Elongation ASTM-D3575 Tear Strength ASTM-D3575 Comp Set @ 25% ASTM-D3575 Comp Set @ 50% ASTM-D3575 Buoyancy ASTM-D3575 Thermal Conductivity ASTM-C177 Thermal Resistance ASTM-C178 Service Temp ASTM-D3575 Water Absorption ASTM-D3575 Comp Creep ASTM-D3575 Flammability FMVSS-302 Chemical…
Main Quality Tests on PET Films are as below:
4 Test method4.1 GeneralThis part of IEC 60811 shall be used in conjunction with IEC 60811-100. Unless otherwise specified, tests shall be carried out at room temperature.4.2 Method A – Measurement of carbon black and/or mineral filler content in polyethylene by direct combustion4.2.1 Sample and test piece preparationA sample of the outer covering or sheath…
