First lets take a look at the tests need to be done on the pipe itself according to this norm: 5 General characteristics5.1 AppearanceWhen viewed without magnification the internal and external surfaces of pipes shall be smooth, clean and free from scoring, cavities, and other surface defects to an extent that would prevent conformity to…
Test Methods and Specimens8.1 Introduction:8.1.1 Three basic vibratory methods exist:8.1.1.1 Forced vibration of a nonresonant system involving only the specimen,8.1.1.2 Free vibration of a resonant system involving the specimen and a mass, and8.1.1.3 Forced vibration of the above resonant system.8.1.2 The first and third can be broken down further into two kinds of apparatus, those…
5 Apparatus 5.1 Impact surface, which should be either: a) a plane inclined to the vertical at 10° ± 1° (for the inclined plane test), or b) a plane vertical to within 1° (for the horizontal or pendulum test). The dimensions of the impact surface shall be greater than those of the impacting face, or…
3 Apparatus 3.1 GeneralTheapparatus shall consist of a jig or any other arrangement capable of: a)applying the specified diametric and/or angular deflection; b)applying the specified test pressure(s), positive or negative; c)maintaining the test assembly in the required position throughout the test; d)resisting the forces resulting from the mass of the water in the test assembly…
5 Apparatus5.1 Electric Furnace, at least 20 cm (7.9 in.) long suitable for use with the tubing described in 5.2.5.2 High Temperature Glass Combustion Tube, 4 of appropriate diameter and approximately twice as long as the furnace described in 5.1.5.3 Stoppers—Two rubber or neoprene stoppers, to fit the tube described in 5.2, unless the tube…
Apparatus3.1 Pressurizing device, capable of applying and regulating the water pressure in the test piece in asinusoidal or trapezoidal form between pressure limits as specified in the reference standard.3.2 Pressure measurement device, capable of measuring the water pressure in the test piece to an accuracy of ±5 %. The device measurement shall be capable of…
Mechanical Tests : There are mechanical tests and physical tests for polyethylene pipes as per mentioned standard as below For above tests that is hydrostatic pressure testing you will need 4 types of equipment: 1- Pressure units (Number of lines are as per customer request and max pressure of testing for PE pipes is less…
6 Equipment6.1 Microtome—A rotary or sledge-type microtome equipped with a sample clamp and knife holder is required. Steel knives are recommended; however, glass knives may be suitable.6.2 Microtome Accessories—Lubricant, dust cover, and tweezers are recommended.6.3 Microscope—An optical microscope with binocular viewing (trinocular type, if micrographs are to be taken) is recommended. This should include a…
Laboratory CNC milling machine from AHP PLASTIK MAKINA has 3 version. Samples of up to 50mm thickness, 100mm thickness and higher than 100mm based on customer request. In two first versions we have possibility of having spindles with two types of tool holder ER16 and ER 20. ER16 collet has possibility of holding tools 2,3,4,5,6,7,8,9,10mm….
5 Apparatus and auxiliary materials5.1 ApparatusThe apparatus shall include:5.1.1 Device, consisting of one or several cylindrical test chambers, horizontally positioned, with theinside dimensions of (152,4 ± 1,0) mm in depth and (146,0 ± 1,0) mm in diameter. In the centre of eachchamber is a horizontal shaft with cross rods (impellers) which rotate at 1 200…
